Changelog of AVCA11XV

02.05.2007
Main 01.53

When AVR/AVC amplifier connects to EPSON EMP-TW1000 with HDMI cable, AVR/AVC amplifier does not understand the resolution of Display.  Therefore a picture does not display properly.
When the customer connected the HDMI output of the source equipment which does not support HDCP (High-bandwidth Digital Content Protection system) to the HDMI input of an AV amplifier, a picture is blinking
When the customer connected the source equipment to the COMPONENT input of an AV amplifier and AV amplifier and Display with HDMI connection, the customer controlled MASTER VOLUME up and down, a Flashing Noise indicates in a picture at once.
The AV amplifier did not support the LPCM 7.1ch digital signal from the HDMI input.
The AV amplifier did not support the Audio Digital signal at PC resolution (SVGA, XGA, etc.) from the HDMI input.


22.12.2005
Main 01.49

After setting the "Surround B = Front B" at the "Power Amp assign", if the Front B was used at the STEREO mode, other channel (Surround A) other than the Front B is outputted simultaneously.
At the serial control from the Ethernet, the unit is incapable of responding to the request command during the STANDBY mode.


09.08.2005
Main 01.45

The following points have to be improved:
The accuracy upon identifying the type of large or small speaker.
The accuracy of the low frequency compensation curve of the Room Equalizer.
The judgment accuracy upon confirming the speaker's polarity.
4) The accuracy to measure the distance of all the speakers.


21.06.2005
Main 01.44

The unit clears the Back-up (initializes the memory) when operations in particular sequence was performed.
The sequence to which the malfunction happens.
Set the unit to the stand-by mode.
Turn off the Primary Power of the unit by using the Power Switch or disconnecting the AC Cord.
Turn on the Power of the unit again. The unit goes into the Stand-by mode.
Turn off the Power of the unit again in the same manner as the item #2).
Approximately 10 seconds later, turn on the Power of the unit in the same manner as the item #3). The unit does not enter the Stand-by mode, but turns into the Power-ON mode, and the memory that should be remembered is erased.


08.06.2005
Main 00.55

During the "3rd Edition of DENON Link" connection, if the STATUS button was pressed during the playback of a SACD at DIRECT or PURE DIRECT Modes, "DOWNSAMPLE 88.2kHz" is indicated on the FL Display.
The product is operating properly. (The playback signal was processed in the DSD.) Also, the indication of the OSD is working properly.






for user with 1080p upgrade please see here:
Changelog of AVCA11XVA

06.02.2007
Main 03.24

Improve the Transaction of Bass management setting.
When the customer connected the HDMI output of the source equipment  which does not support HDCP (High-bandwidth Digital Content Protection system) to the HDMI input of an AV amplifier, a picture is blinking
TRIGGER output turns off when the Headphone connected.
When the customer connected the source equipment to the COMPONENT input of an AV amplifier and AV amplifier and Display with HDMI connection, the customer controlled MASTER VOLUME up and down, a Flashing Noise indicates in a picture at once.
A picture does not output when DVD1930 connects to Display with DVI connection thought AVR/AVC amplifier and play PAL disc.


07.07.2006
Main 03.19

We switch TRIGGER OUT for MAIN Zone on. After change the Surround-Mode for example from Dolby Digital to DOLBY Headphone changes the trigger out signal to be turned off.